Subject: Tailwind Cooling (try again)
From: ACRE NL
Date: 6/21/2001, 5:35 PM


Jerry Hey wrote:

 Paul, here is a revision of the first drawing taking into
 consideration your suggestions on inlet sizing.  I moved the rad-air
 exhaust up the access belly pan, by incorporating louvers.  This
 would lie in the shadow of the intake structure.  I don't know if
 this is good or bad.  Jerry


Maybe.

At high angles of attack (slow speed climb) the bottom of the fuselage
in that area may not be low pressure at all.

I am not sure that will work as well as the under the elevator trick.

Don't worry about the air velocity inside the aft fuselage. The pressure
may be a bit higher than outside (when the flaps are closed) 
but the velocity will be low (because of the
large cross sectional area of the aft fuselage) until it gets
back near the flap openings. Back there is where you need a little sheet metal
guidance for the air flow. The whole idea here is to recover some of
the drag of
the scoops hanging down  under the fuselage with a little hot air
squirting out the back for a minor jet effect.

Paul Lamar


I wish the "jet effect" could be quantified.  Might be doing a lot of
work for negligible returns. Jerry

Perhaps. The P51 designers claimed it canceled the drag of the scoop.
Some say it even added a bit of thrust because the air was heated.
I don't see how those cowl flap back there would be tough to build.
A piano hinge with flat alloy sheet should work fine.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org