Jerry Hey wrote:
Paul, here is a revision of the first drawing taking into
consideration your suggestions on inlet sizing. I moved the rad-air
exhaust up the access belly pan, by incorporating louvers. This
would lie in the shadow of the intake structure. I don't know if
this is good or bad. Jerry
Maybe.
At high angles of attack (slow speed climb) the bottom of the fuselage
in that area may not be low pressure at all.
I am not sure that will work as well as the under the elevator trick.
Don't worry about the air velocity inside the aft fuselage. The pressure
may be a bit higher than outside but the velocity will be low (because of the
large cross sectional area of the aft fuselage) until it gets
back near the flap openings. Back there is where you need a little sheet metal
guidance for the air flow. The whole idea here is to recover some of the drag of
the scoops hanging down under the fuselage with a little hot air
squirting out the back for a minor jet effect.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org