>Its easy Jerry. You get four 180 degree bends from Burns Stainless
 >and weld them in the center to make two 360 degree cut and twisted
 >donuts.
 >
 >Brian's version is made from flat stock where you cut out a split donut
 >side and weld it to the inner can along the bottom of the runner and cover
 >the outside with flat sheet. Probably a wee bit lighter than the
 >round tube donut version.
 >
 >Paul Lamar

 What's the "easy" part?   Jerry

ROFL. I forgot. You don't have a tig :-)

Paul Lamar

  Not true,  I have a Miller 250 Sq. Wave that I have used for about
ten years. I love it and I enjoy tig welding.   It is the only way to
go for many situations but not for everything.--Jerry

Ok so what is not the easy part? What part looks difficult?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org