Subject: oil/water or oil/air exchanger??
From: ACRE NL
Date: 6/21/2001, 6:02 PM



 > Be certain to size your ducting and radiator to transfer the
combined
heat load (coolant & oil).



One third more (area, volume, air etc.etc..) for the main rad. There >
is
no free lunch.

Monty Roberts wrote:

 Sorry guys, I did not mean to imply that the main radiator would remain the
same size as with the air/oil cooler. No free lunch indeed. The water
radiator will have to be sized to reject the additonal energy, no doubt
about it. But the overall area should be less than an air/oil, air water
cooler system because of the better efficiency of the air/water cooler and
the increased delta T. I have been doing this kind of stuff long enough to
know that theory does not always work in reality, but I still like to use
theory to point me in the general direction. If this setup does not work, I
can always place an air/oil cooler on the back side of the radiator I
suppose, but I would rather not do this, due to space considerations and the
like. I could also mount a seperate oil cooler in the wing strake which
would be preferable, but I'm going to try the oil/water aproach first.

There is no tax but upon the people, and there is no cooling but air
cooling. I put the very large Callies (the crank shaft people) oil to
water cooler in the race car. It works great for cooling the oil down >to
almost the water temp. Unfortunately, the water temp went way >up. This
with
the largest Griffin available, (19" x 31" x Two rows). I >took it out and
put in three very large Setrabs. One in the pressure
side and two in the scavenge side.
 >Seems to work great.
Lynn E. Hanover


 In a car I would concur, doubly if it is a road racer where you accelerate
at max power then slow down for the turn just as max heat load reaches the
radiator. Not to mention that this is done at ground level in possibly very
hot conditions. I will be consistently flying over 150 mph in a much cooler
environment. Different application.

For sizing the rad for this beast, I have a few questions for those of you
that are operating these things regularly. What are the typical specific
fuel consumption numbers that you are getting in cruise and climb? (note I
don't need a dyno card type of answer, I just need to do some rough
calculations. I will work out the details on the test stand)  I have used
about .45 lbs/hp*hr for prelim. calcs. Also, what is the typical EGT that
you get at high power cruise and climb? I understand that it will be higher
than a typical piston engine, but how much?


Monty

.45 is a bit low Monty. In full rich climb mode it could be as high as .65.
Sounds high but is also typical of an air cooled aircraft engine in that
mode. I think the best Tracy has estimated in full lean high altitude
cruise is .47. That's your range.... pardon the pun.

As I recall Tracy sees as little as 1400 F in full lean cruise with up
to 1800 F has been seen in full rich full power runs. The side exhaust
port rotary should bring those numbers down as unburned fuel in the
combustion chamber does not make it out to the exhaust pipe to burn there.
The BSFC should also get better for the same reason. We are all waiting
for the RX8 to find out for sure.

"There is no tax but upon the people". I just love that saying Lynn :-) 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org