Subject: oil/water or oil/air exchanger??
From: ACRE NL
Date: 6/21/2001, 11:56 AM


marc wiese wrote:

I also recall that Tracy Crook tried to emulate the early 2nd gen OEM
oil-water cooler (even the car people decry them and update to the later
air cooler) and that it did not work for him, so he added copper pipe to
the oil pan as well (read his book). I think he now has all oil to air
coolers. Right?



Mike Wills wrote:

  That doesnt mean the concept is wrong, just that the execution of the
concept was poor. The factory oil-water cooler clearly didnt have
sufficient capacity.

  A low buck approach to an oil-water cooler might be to pick up several of
those Mazda coolers in the scrap yard and run them in parallel. I agree,
there is no free lunch and in doing this you would have to increase
radiator capacity.

  As I recall Tracy tried the factory oil-water cooler in place of the
air-oil cooler. When that didnt work he went back to the air-oil cooler and
then added that oil pan coolant loop. I've often wondered why he didnt
supplement the air-oil cooler by running it in series with the oil-water
cooler to get the additional oil cooling that he needed rather than running
that loop in the pan? That oil pan loop always struck me as a poor
approach. Since the oil in the pan has very little flow across the coolant
loop (compared to a conventional oil-water cooler plumbed in a high flow
line) it seems that it would be relatively inefficient in transferring
heat. And the idea of punching big holes in the oil pan and brazing in
copper pipe seems pretty scary from a failure mode standpoint. Correct me
if I'm wrong on this Tracy, and if not why didnt you try this?

Mike Wills


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org