Yes it can and some do it that way. The problem for most aircraft is
the space required, the heat and the cost. Here is a picture of one
Paul Yaw did for a float plane.
Here is a little back ground data on intake manifold tuning.
This is for a piston engine but the rotary works in a similar fashion
with different pipe length and diameter numbers.
Paul Lamar
mike h wrote:
Paul, where did that data come from? I'd like to do some research un the
subject (IE really understand it and the physics involved) and should be
able to get stuff from NC State (Engineering college) through interlibrary
loan. My liberal arts college just doen't have squat!
BTW, this and the dynamic chamber post made my 'keepers' file... good stuff.
You might want to tell people that the dynamic intake stuff is from the
89-91 normally aspirated cars. I wonder if there is a SAE paper on the same
thing for the 93+ motors?
Mike
The pipe stuff was from Heinze Hiesler's book Advanced Engine Technology.
Warning... the charts were mis labeled in the book too. I corrected them.
Just search the library computer for "rotary engine". You will get a list
of most technical papers on the subject. Also check the ACRE NL web site
for an OCR list of rotary papers.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org