Subject: oil feed mods on your 2.85 Ross psru?
From: ACRE NL
Date: 6/22/2001, 1:04 PM


snip

Ian & Irene Beadle wrote:

My oil feed to gearbox and return to sump were aluminium tube. The
group
advised that there had been failures due to vibration fatigue, so I
have
changed them all to the flexible type. My 2.85 drive has now done 9
hours
with the thrust bearing and oil feed modifications. No leaks yet and
is
maintaining 3mm play at prop. tip. Prop. speed of 2000rpm gets me
along at
130knots. (gps checked) Waiting for more engine hours before full
power
check. PS. oil air inlet is 4" not 3".
Ian RV6A


    Ian,
     Can you give specifics on oil feed mods on your
2.85 Ross psru? I am following Jerry Bass's input shaft
thrust brg mod. How is your thrust brg holding out?

    Kelly Troyer

--
Dyke Delta/13B Rotary Power


Ian & Irene Beadle wrote:

Kelly
Firstly my gearbox is the 11 1/2" version. This means that with the gears
properly aligned the Jerry Bass 'Top Hat' bearing holder is just a flat
piece of 4130. The oilfeed mod. is an extra feed through the top of the
outer gear. I was advised that premature wear was caused by insufficient oil
to the gears. The existing arrangement certainly did not seem adequate. I
discovered that my outer gear had a 1/8" hole in it at the top. So I drilled
a passage in the alluminium to match up with this hole and tapped it 1/8"
taper for a fitting. The oil now comes from a 50 thou. restricter to a T
piece to the original feed and to the new one. It has only done 9 hours so
far, but here's hoping. My box has two drains one at the bottom and one not
quite at the bottom. Both piped back to the sump. Using Mobil One oil.
What does a Dyke Delta look like?
Ian RV6A

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org