Subject: Perry's new prop shaft
From: ACRE NL
Date: 6/23/2001, 3:19 PM


Perry is thinking of extending his prop shaft and adding
a ball thrust bearing. This is similar to what Charlie
Airsman did on his direct drive Soob.

Here is my first cut on the the design.
Any criticism or comments?


Paul Lamar


Bill Freeman wrote:

 About 20 years ago I was looking at the prospects for
direct drive auto engines in A/C use.  This is exactly
what I decided was the RIGHT way to do it.  The key is
that you need to keep the engine loads the same as in
the car, ie no additional bending or thrust loads, and you
must drive off the flywheel end, unlike essentially all
VW conversions.

I'll take a look at the stress numbers.  I assume 4130 for
the truss structure.  One other issue is greased vs oil
fed on the bearing.  More work, but I lean towards
oil fed for cooling reasons.  Small flex line with a drilled
orifice from the pressure gallery, larger drain line back to the
sump.  Same seals should work.  I'd also put a magnetic
sump plug in with the bearing to permit you to see flakes
early in the spalling failure process without teardown.

Bill

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org