Subject: Perry's new prop shaft
From: ACRE NL
Date: 6/23/2001, 3:28 PM


Perry is thinking of extending his prop shaft and adding
a ball thrust bearing. This is similar to what Charlie
Airsman did on his direct drive Soob.

Here is my first cut on the the design.
Any criticism or comments?

Paul Lamar

vjaqua wrote:

Paul - Just a few questions and comments. Is that the bearing that Charlie
used?
Why did you transition to steel? Aluminum would be structurally adequate,
and avoid the differences in thermal expansion, modulus of elasticity, and
electrochemical potential. What does the engine end look like? Are there
any provisions for torsional damping. or misalignment ? Vance


I was worried about the local bending loads due to gyro reaction of the
prop. I don't thrust aluminum for cyclical bending. 

The gyro loads on the bearings themselves  are real low because they are so
widely separated. The rear main is used as one and this bearing is the
other. That ball bearing is also designed for aircraft controls and as such
it is not rated for speed. It has real big static load numbers however
at 27,500 pounds radial and 12,100 pounds thrust.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org