Finn Lassen wrote:
After Tracy's insistent urgings, I applied pressure to the cooling
system via the overflow tube, using an old bicycle pump. I saw water
drops collect on the lower-most nut of the water pump (underneath the
pulley). So I spent the $55 on a remanufactured pump (why is it so
expensive compared to the pump in my Toyota?). Now the pressure holds
steady at 10 psi after dropping from 16 psi. Sounds like the radiator
cap is leaking.
I guess I'll never know if the water pump seal failed because of a
defective radiator cap slowly leaking water with subsequent overheating
due to low water level or if would have failed anyway.
Anybody got experience with water pump failures on the 13-B? Rare or
common?
No wobble of the shaft, so must have been just the seal that went bad
and not the bearing.
Finn
Perry thought he had a water pump leak so we got an after market pump.
It was real junk. So Perry bought an official one from Mazda.
It always seemed to me the water pump bearing went before the
seal.
Isn't that cold pressure bicycle pump trick great for finding leaks? :-) :-)
BTW Finn check your cowl pressure at 150 MPH for us.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org