Russell Kent wrote:
Paul Lamar wrote:
Machine tool spindles use those [ceramic ball bearings]. Silicon carbide
balls. Same thing that Ianetti uses in his ceramic apex seals I think. So
too in turbo charger ball bearings but those shafts are small.
... and turning at, what, 10,000 RPM? Don't discount the knowlege just
because your prop shaft is 5x bigger. 10,000 RPM 0.5 inch bearing has a 1300
fps circumferential linear speed, while a 2,000 RPM 2.75 inch bearing has a
1200 fps circumferential linear speed.
Russell Kent
You got me Russell. Good work as usual.
The ratio is more like 100,000 RPM verses 5,000 RPM. It is not just circumferential
linear speed but ball diameter and ball RPM due to the gearing up affect
Vance was referring to.
I have no idea how large or small the balls are in a turbo charger.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org