Subject: Perry's new prop shaft
From: ACRE NL
Date: 6/25/2001, 3:25 PM


<snip>

Yes on the shaft diameter. No on the big balls because they are heavy :-)
Maybe we should go to an engine oil  pressure fed plain bearing?

Ok I will try to find something out of a big truck engine like about three
inches in diameter. I got email into Charlie on the bearing he used.

Paul Lamar

Monty Roberts wrote:

I looked in the contact article on this engine. He states that he used a
bronze bush which was honed to the drive shaft for proper clearance. I am
planning on using pressure fed plain bearings in my redrive to save weight.
If you guys find a good truck engine bearing, let me know. I need one with
an integral thrust washer. I wish that I could find one similar to a cam
bearing that could be driven into a bore. This would make assembly and
design a lot cleaner. 

I searched halfheartedly for such a beast a couple of
weeks back, but did not find anything right away. Sizing the radial bearing
is fairly easy, there is a lot of empirical data available. The thrust
washer design is not as straight forward and will require a little more
digging to find the right info. (maybe the fastest way is to just copy the
front of an appropriate hp aircraft engine :-) I had intended to place the
planetary gear box near the engine and drive the propshaft similar to Paul's
design. I was going to feed the gearbox through the E-shaft and return the
oil through an extended oil sump (No external lines!!). It occurred to me
last night that I could save a lot of weight if I would quit worrying about
how "clean" the exterior of the engine looks (I was violating my form should
always follow function maxim) and move the gearbox to the prop hub. This
does a lot of things:

1.) It means that you can eliminate the bell housing, the extension housing
etc (heavy, expensive, and hard to fab)

2.) The gearbox becomes a cute little thing at the end of the tube truss
structure (which you need anyway for the outboard bearing)

3.) The prop hub and shaft becomes very short and light.

4.) I get to eliminate one of the bearings

5.) The drive shaft now rotates at engine speed, thereby transferring much
less torque (roughly half), and I can make it about half the weight of a
shaft downstream of the gearbox. (will have to watch out for shaft whirl
though)

This all sounds good, but there are some drawbacks:

1.) more seals and tubes to leak or fail

2.) moves the CG aft

When I get some numbers put to this thing, and have a cad file to post, I
will.

Monty

PS. Isn't there a Winston Churchill quote about "NEVER, NEVER, NEVER, GIVE
UP!!!!!"

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org