Perry Mick wrote:
"Perry J. Mick" wrote:
This is for a future project, in which I may try to turn a
50" prop to 4000 RPM with a turbocharged engine.
But I would also like the option of running up to 6000
RPM with the NA engine. So the bearing should be
capable of that speed. Paul, you mentioned the possibility
of a sealed bearing?
That bearing is technically not sealed but perhaps a sealed version
is
now available. You will have to order a newer Fafnir catalog.
If a sealed version cannot be obtained you will have to provide oil
seals and perhaps an oil supply as suggested by Bill.
I forgot to answer Vance's question. I don't think so. As I recall
Charlie used a plain bearing pressure fed.
Paul Lamar
The bearing that you show would appear ro have too small ball
diameter.
The turbo machinery designers at Rocketdyne use a DN factor relating
diameter to rpm. As you can imagine what the ball rpm would be when
the direct drive shaft is turning 5000 + (for Perry).
Unless you reduce the shaft diameter( I know! that goes against all
your
instincts), you will need some cooling flow for the higher rpm
applications.
His approach of a pressure fed "plain" bearing has a lot of merit,
but some compliance must be provided to keep bending loads away
from the bearing.
You are right in that I had misplaced the other picture which
showed the elastomeric drive coupling which looks very good.
I still favor aluminum for the flange. The increased section for
the same weight is much stiffer, and years of prop extensions,
some over 12 inches, have demonstrated that aluminum works
just fine - Vance
Yes on the shaft diameter. No on the big balls because they are heavy
:-)
Maybe we should go to an engine oil pressure fed plain bearing?
Ok I will try to find something out of a big truck engine like about
three
inches in diameter. I got email into Charlie on the bearing he used.
Paul Lamar
I'm just beginning my education on bearings. Just received
a catalog from Barden, also downloaded the pdf files from
Torrington. In the Barden catalog they mention ceramic ball
bearings have a longer life, less vibration due to smoother
surface, work at higher rpms because the balls are lighter.
Maybe this is something to look at?
--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com
Machine tool spindles use those. Silicon carbide balls. Same thing that
Ianetti uses in his ceramic apex seals I think. So too in turbo charger
ball bearings but those shafts are small.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org