"c.l. smale" wrote:
I would not use the alum-carbon drive shaft as drawn. there is a corrosion problem between alum and carbon. we had quite a time with this problem in wind surfing booms. The parts are in water quite a lot which accelerates the problem. You should transition the carbon to the steel piece to carry torque loads. you could use a thinner wall alum tube and let corrosion remove it in time. If you wrap the tube yourself look at the Gugeon Brothers epoxy for this use. They have a industrial grade system which requires post cure to develop good strength. Any help you need in construction you can post at this site and I will answer. Perhaps there are more experienced composite people out there who would be willing to give advice.
c.l. smale
smale@ncinternet.net
Good point C.J. I forgot to mention the thin layer of glass cloth most
people use to insulate the carbon from the aluminum.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org