Did not even check the alternator clearance as I need to move it on the
side of the engine anyway. You could use a smaller alternator like the Kubuto
tractor version. That off set stock front (rear) runner is one of the the
main
problems I cannot use the lower manifold. The new one will be symmetrical.
Probably under $100 for the casting if you mill
the flat side that contacts the rotor housings and drill all mounting holes.
You guys with RV4's non turbo's don't have the tight clearance proplem anyway.
180 degree tubing bends with a flange would probably work fine. I thought
you had
a six port anyway Mike.
Paul Lamar
Mike Wills wrote:
Paul,
Gotta go with the stock alternator mount because there is absolutely no
way to hang it off of the side. I'm using an oil cooler mounting location
similar to Chuck Dunlap's and need to duct over the top of the engine so
any clearance I can gain there will help.
Do you or anyone else have more details on that smaller Kubota
alternator. Size? Weight? Cost? Output capacity? And a source to buy from?
I now have a 4 port engine from Bruce T. Built to same specs as Tracy's
engine.
I'm actually now concerned enough about my oil cooling situation that I
think I'm going to add a second oil cooler. I can put a second smaller oil
cooler under my prop spinner. What is the consensus opinion on how to plumb
2 oil coolers? Series or parallel? I realize that parallel would be more
efficient but how do you balance the flow if you go this route? This flow
balance would appear to be a particular problem in an installation where
the 2 coolers arent the same size such as what I'm considering.
Mike Wills
I have nothing on the Kuboto but a lot of AC engine guys are beginning
to use them. Just stick a piece of 1-1/2 inch pipe in back (front) of
the alternator and tell me if you can get the side of the pipe up to
the edge of the rotor housing. My new manifold keeps all pipes within
the width of the rotor housing.
Don't panic on the cooling yet Mike. Wait till we get the cowl pressure
data from Finn, Ed and Tracy. We may be fooling ourselves into
thinking cooling is more of a problem than it really is.
Parallel is the way to go for low oil pressure drop. The Mazda is
a two pass already. If you used two in series you would have more
oil pressure drop.
Check out a Howe Racing Dunham-Bush oil cooler. 15" wide 6"
tall #12 male pipe thread each end. That is almost twice the area
of the stock Mazda cooler. Weighs 7 pounds dry. $370.
(517) 435 7080 Premium quality according to the Howe catalog.
Paul Lamar
Ken Powell wrote:
Mike,
I have the Kubota info at the office. I will send it to you
tommorrow afternoon (I'm going to be in meetings
all morning - gosh, I hate meetings!).
Ken Powell
kenpowell@aristotle.net
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org