Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 6/27/2001, 3:48 PM



Been agonizing over this for quite some time now.
I considered using the lower portion of the 4 port
turbo manifold and milling it off low enough so I could get
a standard 2.5 inch radius 1-1/2 inch diameter tubing bend
in there. The Kis Cruiser is quite a problem as there is a
minimum amount of distance between the thrust line and the top
of the cowl. The intake runners must be right down on
top of the rotor housing. 2.5 inch radius bends will just
barely fit.

Well I tried that and the holes
I got in the shortened stock intake manifold were not even close
to round. :-(. There would be a big problem getting a good match
between the 90 degree bends in round tubing and the those weird holes.
See the picture below.

Besides that the bends alone would cost $25 apiece for a total
of $100 for all four. That would off set the cost of a cast manifold
with all the bends cast in.

The next idea was to get a real big chunk of
3" by 4" by 12" long aluminum, bore eight big holes in it and carve
out runners that transition from the ovals in the end housings
to round pipe 90 degrees away with a die grinder. Real heavy
and a tremendous amount of work. :-(

I finally said the heck with it and I have decided to have this casting
made regardless of the cost. I will only buy ten so if anybody
wants one of these let me know soon. I will require a deposit
just before I have them cast. I have a meeting with the pattern maker
tomorrow so the design might change. This will work stock
turbo or no turbo. It will accept a simple rectangular flange
with four tubes welded in for intake runners.

Paul Lamar

Mike Wills wrote:

Paul,

  It looks to me like this may not work with the stock Mazda alternator in
the stock location attached to the thermostat housing. On the factory NA
manifold that I used as a starting point the rear port/runner (as installed
in the airplane) sweeps forward quite a bit to clear the back of the
alternator. From the pic I've attached there appears to be a fair amount of
clearance but I would like to measure it first before commiting.

  Do you have a guesstimate on weight and cost? I could consider this if
for no other reason just to clean up the cosmetics of my current setup. It
would also save me some work with a die grinder and JB Weld to port match
my current 6 port manifold to my 4 port engine. On the other hand it also
looks like it may not be compatible with my current runner spacing across
the top of the engine. I dont want to have to start over. I'll have to take
a look at that alternator clearance and runner spacing before I can give
you an answer. I'll check the clearance, and get back to you tomorrow.

Mike Wills

Did not even check the alternator clearance as I need to move it on the
side of the engine anyway. You could use a smaller alternator like the Kubuto
tractor version. That off set stock front (rear) runner is one of the the main 
problems I cannot use the lower manifold. The new one will be symmetrical.

Probably under $100 for the casting if you mill 
the flat side that contacts the rotor housings and drill all mounting holes.

You guys with RV4's non turbo's don't have the tight clearance proplem anyway.
180 degree tubing bends with a flange would probably work fine. I thought you had
a six port anyway Mike.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org