Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 6/27/2001, 4:11 PM


Finn Lassen wrote:

What happened to the simple manifold plate (Tracy sells) and 180 degree
bends?

Finn


Won't fit the stock turbo and the 180 bends are more money than the 90 degree
bends.
Not only that it is a six port. Last time I checked. Unless he had
some four port versions  made. You got four port flanges now Tracy?

Paul Lamar

Bulent Aliev wrote:

Paul, 180 degree alum. bends (from Burns Stainless) will fit with the turbo.
I made the flange and the middle two runners are shaped. I misjudged the
size for the outside ones, so I have to go for the 2" tube. The middle ones
are tricky, that's why I was thinking of a single runner. But since I'm not
an engineer, didn't have the balls to go ahead with it? Any Ideas?
Bulent
Cosmo 13-B

Are you sure about that stock Mazda turbo fit Bulent. 89-92? Not the dual 93 and up.
The 89-93 is very tight indeed.

The single runner for the center housing will screw up the tuning.
Now if it is a single runner for front rotor and a single runner for the
rear rotor that might work.


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org