George Lendich wrote:
"c.l. smale" wrote:
I would not use the alum-carbon drive shaft as drawn. there is a
corrosion problem between alum and carbon. we had quite a time with this
problem in wind surfing booms. The parts are in water quite a lot which
accelerates the problem. You should transition the carbon to the steel piece
to carry torque loads. you could use a thinner wall alum tube and let
corrosion remove it in time. If you wrap the tube yourself look at the
Gugeon Brothers epoxy for this use. They have a industrial grade system
which requires post cure to develop good strength. Any help you need in
construction you can post at this site and I will answer. Perhaps there are
more experienced composite people out there who would be willing to give
advice.
c.l. smale
smale@ncinternet.net
Good point C.J. I forgot to mention the thin layer of glass cloth most
people use to insulate the carbon from the aluminum.
Paul Lamar
Paul, C.I.,
>From discussions with those with carbon experience is that hand lay-up of
carbon
is not a desirable way to go due to the fact you can't guaranteed consistant
outcomes
in strength . However I have seen much in the way of manufactured
carbon tube under 'controlled conditions', perhaps someone can do what you
need
or can supply ex-stock.
George (down under)
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org