Subject: Back in the Air
From: ACRE NL
Date: 6/28/2001, 11:09 AM

Perry Mick wrote:

Put my plane back together.  Sanded the carbon prop blades
and put a layer of fine weave kevlar on, wrapped around the
leading edge.  I was hoping this would eliminate erosion on
the leading edge, but doesn't look like it's going to work.
Already got a little ding from a pebble, and the kevlar just
leaves little frizzled edges wherever it gets poked.

Borrowed a dynamic balancer setup and easily balanced
the system.  It's amazing what effect only 30 grams (about
1 ounce) at the right place will do, on only a 3" radius at that.
It's now as smooth or better than ever.  Will fine tune it
later in the air at 5000 RPM.

Flew once around the pattern this morning.
The cooling problem is still there.  Temps much higher
than before.  Either one or both of the rads is plugged, or
they are internally coated and are not working nearly as
well as before.  So I'm taking the plane down for a few
weeks to install the new rad and ducting.  Also cowl
changes.  I may attend Arlington on the weekend but
my plane probably won't be there this year.

--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org