Subject: Back in the Air
From: ACRE NL
Date: 6/28/2001, 4:31 PM


Perry Mick wrote:

Put my plane back together.  Sanded the carbon prop blades
and put a layer of fine weave kevlar on, wrapped around the
leading edge.  I was hoping this would eliminate erosion on
the leading edge, but doesn't look like it's going to work.
 > >
Flew once around the pattern this morning.
The cooling problem is still there.  Temps much higher
than before.  Either one or both of the rads is plugged, or
they are internally coated and are not working nearly as
well as before.  So I'm taking the plane down for a few
weeks to install the new rad and ducting.  Also cowl
changes.  I may attend Arlington on the weekend but
my plane probably won't be there this year.

--
Perry J. Mick
Duckt N7XR

Ed Anderson wrote:

Perry, keep in mind that if your new engine is putting out more power than
your old one then what may have been adequate cooling on the old engine may
longer be so.  I noticed that when I replace my 86 six port with the 91
turbo block that my coolant and oil temps increased approx 8 degF - same
cooling system as before.  So the bad news is you may need to increase you
cooling capacity, the good news may be its because you are producing more
power and that's not bad news {:>).

Ed Anderson.

I don't think so on the power Ed. Perry reports pretty much the same
RPM's. We used some BarsLeak type stuff as an attempt to plug some leaks 
and I think it may hve plugged the rad :-) I wanted to have it cleaned
out in Palm Springs but Perry was out of time. His rad is tiny by
most standards. About 13 by 14 by 2 inches. Worked pretty
good too because it was a pusher with no back pressure in the cowl
due to leaks around the spinner :-) No spinner either! 

Just bugging you Ed :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org