Subject: Back in the Air
From: ACRE NL
Date: 6/28/2001, 8:05 PM


 > Ed Anderson wrote:

Perry, keep in mind that if your new engine is putting out more power
than
your old one then what may have been adequate cooling on the old engine
may
longer be so.  I noticed that when I replace my 86 six port with the 91
turbo block that my coolant and oil temps increased approx 8 degF - same
cooling system as before.  So the bad news is you may need to increase
you
cooling capacity, the good news may be its because you are producing
more
power and that's not bad news {:>).

Ed Anderson.


I don't think so on the power Ed. Perry reports pretty much the same
RPM's. We used some BarsLeak type stuff as an attempt to plug some leaks
and I think it may have plugged the rad :-) I wanted to have it cleaned
out in Palm Springs but Perry was out of time. His rad is tiny by
most standards. About 13 by 14 by 2 inches. Worked pretty
good too because it was a pusher with no back pressure in the cowl
due to leaks around the spinner :-) No spinner either!

Just bugging you Ed :-)

Paul Lamar


Well, since I did not put leak plugger in my radiator - My story is my temps
went up due to more power and I'm sticking to it  {:>).

Paul, as an aside, doing some research on turbochargers and looking at the
small clearances with stock turbo II manifolds, I noticed that there is an
"ON-CENTER" T4 turbine housing (Turbonetics) that moves the centerline
(shaft) 2.5" away from the intake manifold side compared to our "OFF-CENTER"
manifold bracket. The bracket dimensions appear to be the same as for the
Hitachi HT-18S (Turbo II),  I would think this could provide more room for
intake manifold alternatives. However, this housing does not have the
integral waste gate and of course, it would cost a few bucks more than we
would like to spend, but might be worth it if it permitted more freedom of
choice in other areas.. Just though I would bring it to your attention.

Best Regards

Ed Anderson

I have no doubts about your increased power causing higher cooling demands.
I just don't think Perry's new engine had any more power than the old
engine. Same everything. Stock manifold, stock mass air flow sensor, stock
Mazda computer, stock Mazda exhaust manifold. Stock Everything!

I don't want to deviate from the stock turbo because many problems
are solved by Mazda and the price is 1/4 of what an after market turbo
would cost. I could get a bit more room by putting in a 1/2 inch steel
spacer between turbo and manifold but that means a lot of the turbo
plumbing will have to be redone.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org