Subject: Belt PSRU ??????]
From: ACRE NL
Date: 6/28/2001, 7:54 PM

Jerry Hey wrote:

 > Bill:
 Is there any belt PSRUs that you have seen that you would recomend? What
 brand would you choose?
 Also, what would you do to improve it, and why? I like the idea of a belt
 drive, myself. They seem to have
 been around for a long time with a pretty good track record from what I have
 heard. Cheap to maintain also.
 Rich Gillen

The big problem with a belt drive is they waste precious space
inside the cowl by
uselessly lowering the engine. This almost precludes using one rad
under the engine.
It gives more room of course over the engine which is of little use in most
airplanes. In only a few designs like the Kis Cruiser and the Lancair
320/360 is room above the engine real tight and that only by an inch or
two.

Paul Lamar


Bill,

I'm using a chain drive with 5.5" offset. This allowed me to lower
the engine 3 inches to fit under the Tailwind cowl which slopes
downward on top and  still have room for the oil filter and water
pump outlet without modification while at the same time gaining 2
inches of precious prop clearance.  To fit the planetary gear drive
under the Tailwind cowl I would have had to lower the engine one
inch, relocate the oil filter, modify  the water pump outlet and give
up one inch of prop.     To give up the security of Tracy's proven
unit was very hard to do.     Jerry


Ah So! This is why you cannot get a rad under the engine. 
I understand now :-)

The oil filter is a minor relocation problem.
I take it you still had to move the alternator.

Cutting down the water pump is not much of a problem.
Especially for a welder. See the picture of the
pump I cut down. I used a machined tube but the trick is
to weld the hose barb back on that you cut off in the first
place.

You should have used a 14 inch spinner and placed a half cone
on top of the cowl :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org