Chuck wrote:
Here are a couple of pictures of my inlet duct progress. The photo
"InletDuct.jpg" is the "before" shot I have been flying. The blue thing at
the end of the manometer tube is an aquarium bubbler stone from Wal-Mart to
diffuse the pressure and eliminate pitot ram effect. Photo "inlet
duct1-3.jpg" is what I flew yesterday. I widened the inlet at the top where
it joins the cowl and hot-glued some cardboard "lips" and shaping pieces. I
was able to climb out at full power on an 80 degree morning today and saw a
max coolant temp of 205F. Pressure was 7" of water. This is encouraging! I
now think my 10" x 20" radiator is big enough, with the right duct it will
do fine. It looks like a 12" wide opening by 2-1/2" tall (only 30 Sq. In)
might work as long as it is right next to the cowl and not offset like a
snorkel. I don't think there is any slow boundary layer airflow in this
location to worry about. I am going to cut off the whole inlet and start
over. Thanks for the offer to help Paul!
Chuck Dunlap
Before you do anything else chuck Please seal the hole around and behind the
spinner and all other leaks at the front of the cowl and take a few more
cowl pressure readings for us.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org