This is why I finally gave up and bit the economic
bullet and decided to cast an intake manifold.
John Slade wrote:
Paul,
I might be a customer for the cast intake if it'll fit my '93 3rd gen. I'll
need one in a few weeks. I was thinking of using a composite intake, but
hadn't considered the heat soak problem. I don't have a height issue. Greg
Richter may also be a customer. I think he's planning to have a cast made
also. Greg?
We definitely need an off the shelf solution to the intake system. Once you
settle on the turbo, it's about the only major unknown left. Will your
intake manifold accommodate stock injector rails and throttle body? I need
everything between the fuel pipe and the intake ports.
By the way, I heard Greg's turbo run a couple of days ago. No muffler and
that thing is QUIET! Much quieter than a Cessna and very sweet sounding.
I'll be able to do test run ups on my patio without even upsetting the
neighbors!
John Slade, Cozy MKIV #757, progress: http://kgarden.com/cozy
West Palm Beach, FL
(Engine mounted - making lower cowl.)
You third gen guys have larger intake port engines. This casting I think will have
runners that are too small.
If you have the room, go for the 180 degree
bends as they only add a few inches to the height of the engine.
You can run the tubes directly over the top of the center and end
housings. Using the stock 89-92 turbo you will have to use Bulents
trick of cutting off the 180 tube early so it clears the turbine housing
and better matches the oval ports I think.
On the other hand if you all get together and want a casting I will ask
the pattern maker today how much he wants for two patterns. Perhaps
we can make two sets of cores. Make a sketch of the bolt pattern and third
gen ports for me. We need it fast as we are going balls to the wall on this.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org