Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 6/28/2001, 11:03 AM


I finally said the heck with it and I have decided to have this casting
made regardless of the cost. I will only buy ten so if anybody
wants one of these let me know soon. I will require a deposit
just before I have them cast. I have a meeting with the pattern maker
tomorrow so the design might change. This will work stock
turbo or no turbo. It will accept a simple rectangular flange
with four tubes welded in for intake runners.

Paul Lamar

Ed Anderson wrote:

 Paul,
    I just went out and stuck the exhaust manifold and turbo from my 91
Turbo II block on a block.  I measured 1 3/5" clearance on the turbo
compressor end and 2" clearance on the turbine end between those parts and
the rotor housings/side housing. The room for the intake manifold height.
I slipped the turbo II lower manifold on and Man it was tight between it and
the compressor housing like MAYBE 1/8" clearance.  I can't tell  the exact
spot on the slope of your casting design that would correspond, but since
your one height measure shows 2.770 inches - I am concerned that you might
not have the clearance you need - particularly on the compressor side.  I am
probably wrong, but wanted to give my measurements to you before you
committed on a casting. Might be worth a double check.

Best Regards

Ed Anderson

Thanks Ed.
It is tight all right but I think the manifold as shown in the drawing
will fit. The turbine housing kind of fits between the two back intake
runners.

Did you seal the hole in your cowling behind your spinner yet? :-)

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org