Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 6/28/2001, 11:17 AM


 > > Been agonizing over this for quite some time now.
 > > I considered using the lower portion of the 4 port
 > > turbo manifold and milling it off low enough so I could get
 > > a standard 2.5 inch radius 1-1/2 inch diameter tubing bend
 > > in there. The Kis Cruiser is quite a problem as there is a
 > > minimum amount of distance between the thrust line and the top
 > > of the cowl. The intake runners must be right down on
 > > top of the rotor housing. 2.5 inch radius bends will just
 > > barely fit.
 > >
 > > Well I tried that and the holes
 > > I got in the shortened stock intake manifold were not even close
 > > to round. :-(. There would be a big problem getting a good match
 > > between the 90 degree bends in round tubing and the those weird holes.
 > > See the picture below.
 > >
 > > Besides that the bends alone would cost $25 apiece for a total
 > > of $100 for all four. That would off set the cost of a cast manifold
 > > with all the bends cast in.
 > >
 > > The next idea was to get a real big chunk of
 > > 3" by 4" by 12" long aluminum, bore eight big holes in it and carve
 > > out runners that transition from the ovals in the end housings
 > > to round pipe 90 degrees away with a die grinder. Real heavy
 > > and a tremendous amount of work. :-(
 > >
 > > I finally said the heck with it and I have decided to have this casting
 > > made regardless of the cost. I will only buy ten so if anybody
 > > wants one of these let me know soon. I will require a deposit
 > > just before I have them cast. I have a meeting with the pattern maker
 > > tomorrow so the design might change. This will work stock
 > > turbo or no turbo. It will accept a simple rectangular flange
 > > with four tubes welded in for intake runners.
 > >
 > > Paul Lamar

Finn Lassen wrote:
 >
 > What happened to the simple manifold plate (Tracy sells) and 180 degree
bends?
 >
 > Finn


Won't fit the stock turbo and the 180 bends are more money than the 90
degree bends.
Not only that it is a six port. Last time I checked. Unless he had
some four port versions  made. You got four port flanges now Tracy?

Paul Lamar


mike h wrote:

Racing beat sells flanges for intake and outlets for whichever port combo
you can devise, and IIRC they are 1/2" thick and cut on a water mill.

www.racingbeat.com

this is a newish thing for them...

Mike Harrington

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org