Gary Palmer wrote:
Hi Paul,
You may recall that Lancair's present a similar problem with only 1.25" clearance at the top of the cowl. I suspect you are not quite as constrained. Can you tell me exactly how much clearance your design will require above the engine (clear reference point)? Alternatively if you can provide a DXF file, I can import that into my TurboCAD dwgs and figure out if this is a possible solution for my case.
Have you given any thought to squeezing the top runners down to an oval shape (essentially like the outer ports rotated 90 degrees). I have trimmed down my intake manifold much as you have and was planning to make fibreglass one the rest of the way and use a higher temperature epoxy, or possibly a high temp Vinyl Ester. An all aluminum one would be better. Nonetheless, I might be a customer if the price is reasonable as it would be easier to adapt to the upper section of your casting and would plug some of those strange ports in the turbo housings.
Cheers........Gary
Gary L Palmer
Lancair 235 C-GPLM
gpalmer@NortelNetworks.com
The highest bell housing bolt boss on the end housing touches the cowl.
I can just get a pieces of 1-1/2 inch tubing on top of the rotor
housing to fit in there if I cut off the rotor housing
machining bosses. I don't know of any CAD drawings accurate enough for these
kinds of problems. The best thing to do is mock it up with an actual
engine. If you are not going turbo you won't have the problem
as a wrapped up manifold should work fine.
Squeezing the pipe might pick up a 1/2 inch but then the bell housing bolt boss
would be the limit and you need that. A small power bulge in the cowling
might not look bad :-) Especially if you use an extra large spinner.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org