Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 6/28/2001, 2:01 PM

Mike Wills wrote:

  Similar to Tracy's setup, using the 88 NA lower manifold and part of the
upper to make the turn across the top. No plywood. :-)
  Instead of copying Tracy's "dynamic chamber" I went with a very small
volume plenum with curved outer wall. I'm not sure how this will perform.
Conversations with Paul Yaw led me to believe that any losses due to less
dynamic effect would be offset by the improved flow characteristics of this
sort of throttle body mounting as opposed to Tracy's setup which requires
airflow to make a sharp 90 degree bend into the runner. And this config
clears the cowl without a large bump. Still need to add secondary
injectors. They wont fit in the 6 port actuator holes (cowl clearance
issues) like Tracy did so will have to mount them up on the runner somewhere.

Mike Wills

I suspect that 90 degree turn is necessary for a dynamic chamber design.
A bit of a drawback in some cases as it makes the manifold higher
as you mentioned the bump in Tracy's  cowl.

Your manifold looks to be only about two or three inches higher than the
one I need. That must be an NA 88 six port lower manifold you have there.
Did you weld on it to convert it to the four port hole pattern?
What did you do with your oil filler neck and dip stick?

I also noticed you moved the starter from the bottom where Tracy
had it on his stock redrive plate :-) Nice looking rad duct there.

I'll send the other picture in a separate email.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Mike-Wills-intake-LS2.jpg