Mike Wills wrote:
Similar to Tracy's setup, using the 88 NA lower manifold and part of the
upper to make the turn across the top. No plywood. :-)
Instead of copying Tracy's "dynamic chamber" I went with a very small
volume plenum with curved outer wall. I'm not sure how this will perform.
Conversations with Paul Yaw led me to believe that any losses due to less
dynamic effect would be offset by the improved flow characteristics of this
sort of throttle body mounting as opposed to Tracy's setup which requires
airflow to make a sharp 90 degree bend into the runner. And this config
clears the cowl without a large bump. Still need to add secondary
injectors. They wont fit in the 6 port actuator holes (cowl clearance
issues) like Tracy did so will have to mount them up on the runner somewhere.
Mike Wills
Here is Mike's other picture.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org