Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 6/28/2001, 4:23 PM

Mike Wills wrote:

Paul,

  You may be right on the 90 degree turn. Someone over on the other list
mentioned doing some crude flow testing with a similar manifold (i.e.
throttle body at the apex of the U) and reported that all the airflow
followed the turn rather than leaking out the TB. But of course that wasnt
a dynamic test. As I said, Paul Yaw felt any lack of dynamic effect (he
wasnt certain of this either) would be offset by the flow improvement. We
shall see.

  With tubular aluminum I could make it closer, but when I built this I
thought I was going to use the NA engine. And didnt think I needed any more
clearance. Port matching the tubing to the 6 port config looked like too
much work so I went this route. Port matching to the 4 port from tubing
should be a lot easier. I'll probably make first flights with this but I do
anticipate a change sometime in the future.

  I havent done any matching of this to the 4 port housings yet. Probably
will just fill the ports with JB Weld before grinding rather than welding.

  Its an old picture. Didnt like the fit of the duct that came off of that
plug in the picture. Did it over in aluminum. Lighter and stiffer than the
fiberglass piece. Still need to make a small fiberglass piece to match my
sheetmetal duct to the cowl. I'll try to get some new pics soon.

  Custom aluminum oilpan with the sump relocated rearward. Needed that to
clear the rad duct. Oil filler/dipstick will be welded into the pan (that
part hasnt been done yet). Dont have any pictures of that yet.

  Here's the intake you need. I've sent you this before but a little
refresher couldnt hurt. This engine (including intake and exhaust
fabrication) was built by Racing Beat.

Mike Wills

Bruce Frank is building a  similar oil pan for me as we speak.
Good price too $70.

That sure was beautiful work all right but notice the missing flange bolt :-)
It is a real shame this engine never flew.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org