Subject: Back in the Air
From: ACRE NL
Date: 6/29/2001, 9:19 AM

I don't think so on the power Ed. Perry reports pretty much the same
RPM's. We used some BarsLeak type stuff as an attempt to plug some leaks
and I think it may hve plugged the rad :-) I wanted to have it cleaned
out in Palm Springs but Perry was out of time. His rad is tiny by
most standards. About 13 by 14 by 2 inches. Worked pretty
good too because it was a pusher with no back pressure in the cowl
due to leaks around the spinner :-) No spinner either!

Just bugging you Ed :-)

Paul Lamar

Finn Lassen wrote:

Actually Ed has one of the smallest cracks between spinner and cowling I've seen.
Doubt it's more than 1/8".

Finn

The spinner gap has little to do with it.

If the spinner is 12 inches in diameter that is 1.5 square inches
or .0104 square feet. At about 200 mph or about 300 feet per second that 
is about 3 cubic feet of air per second or 180 cubic feet per minute.
The cowl volume is about 3 feet by 3 feet by 3 or 30 cubic
feet. That is enough air flow to change the air in the cowl every 10 seconds.

Now if one put fins on the spinner backing plate it might act like a centrifugal 
pump and pump a bit of air out of the cowling helping the cooling. Won't pump much
because 2500 RPM and 12 inches in diameter is nothing for a centrifugal 
air pump. BMW had to gear up the cooling fan driven from the nose of the 
crankshaft in their WW II radial engines.

We are in dire need of those cowl pressure measurements. This data is
extremely important and critical to the success of cooling a rotary engine.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org