Subject: Belt PSRU ??????]
From: ACRE NL
Date: 6/29/2001, 1:10 PM


Paul wrote:

The water pump housing does not wear out unless you let the water
pump cavitate. The 15 year water pump cartridge itself is unchanged.

Of course.  I think I will end up following your lead on this.  The
additional pics and comments would be appreciated.  I do have a mill.


Is that a stock alternator or an extra small one?
Nice trick for lowering the alternator.

If I recall rightly, it is a Mitsobishi 75A.


If you run the engine with out the thermostat make sure you block
the bypass passage. I have a bunch of pictures on the cut down pump if
you need more info on that. Running with a thermostat and no
cowl flaps is not the hot tip for low cooling drag.

You have said this before but I don't know what there is about a
thermostat that would slow things down.  Flap doors can still be
operated.  I go back and forth between the utility of the thermostat
as opposed to its potential failure.  I haven't had one fail in
twenty years.  I wonder how accurately one can control the temps
manually operating the outlets.  Would it be a case of constantly
adjusting them?  Jerry


Paul Lamar

Nothing about the thermostat per se.
The use of the thermostat implies you do not use cowl flaps to control
engine temperature. 

Cowl flaps cut cooling drag by restricting air flow through the 
cooling system when max cooling is not needed. Say high speed cruise. 
This reduction of airflow through the high drag cooling system results 
in less overall aerodynamic drag. In a C182 it is worth several MPH 
at only 150 MPH. Since drag doubles again at 200 MPH it could be worth 
maybe 6 MPH or more.

This is what the water pump looks like after you cut it off
with a band saw or hack saw. Surprisingly and inexplicably the 
big passage is the bypass passage. It does not make sense
to restrict the flow here as all the restriction you need
is in the block and or in the radiator. 

The one with the flashlight shinning through
is all the return flow from the block. You hack this partition
out with a die grinder and weld in  a new partition with a
resulting increase in flow capacity out of the block.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org