Jerry wrote:
Here are two pics of my alternater installation. Still don't know
if the water pump will be as shown without thermostat or back to the
tall outlet with a thermostat. I got to dream about that some more.
Jerry,
I forsee two problems with your alternator & water pump installation:
#1. The belt wrap on the water pump is so little, I wonder if the belts can transfer
the needed horsepower without slipping. Slipping, of course, is bad not only because
you aren't getting the power transferred, but also because it overheats the belts
which can eventually lead to early belt failure. I think you need a backside idler
pulley between the water pump and the alternator to give a few more degrees of
contact.
#2. If you are counting on the double row of belts to provide redundancy in the event
that one of the belts fails, you're in for a surprise. A failure of one of the belts
will likely cause the other belt to fail because of the belt debris from the first
belt failure. If you can slip a bit of perforated sheet metal between the two belts,
and maybe even "cage" both belts with more perforated sheet metal, then the system is
more likely to survive the failure of one belt.
Russell Kent
Good point Russell. Thanks for catching that. I had to add an idler
on my set up to get the wrap on the e-shaft pulley.
Somebody mentioned a serpentine belt and in some case some accessories might
be able to be driven by the back side of the serpentine belt if one has
at least 180 degrees of wrap. Probably just the alternator. I now notice
that Summit Racing is selling serpentine pulleys. Another possibility is
a cog belt drive.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org