Finn Lassen wrote:
How does the machine work that removes material with an arc or spark?
If it wasn't for the CA blackouts, I guess you could hook up one of those to a 3-D
robot arm controlled by your CAD/CAM computer :)
How much power do these units use and do they use up the electrode supplying the arc?
What happens to the material used?
Finn
Large mass removal by EDM is generally not a good trade for several reasons. Tool loss rate
is a real factor, 25 percent of the tool to part wear is not uncommon. The material removed
(from both) reconses as a fine black powder that is washed away by the dielectric fluid.
Something to consider for this application is "lost styrofoam" casting. You sculpt your
part
from easily removed blue foam, and ship it off to a casting house. The foam is vaporized
by the incoming melted aluminum. Good detail, and no fancy cores - the downside - you
have to make a new sculpture for each pour. - Vance
I think I might try that Vance. That sounds like it might work.
How would you make a hollow runner? Just carve it out from two
pieces and glue it together? Perhaps John Lynch can 3D machine
the styrofoam runner halves from a program. Can the foundry
stuff sand down in the runner with out breaking the foam?
Is blue foam the best to use or perhaps some other finer grain
foam? I think in production they use a mold and steam expanded styrofoam
beads that give a smoother surface finish.
I think the big advantage to this is you do not have to worry about
drafts or getting the pattern out of the sand.
What about the lost wax process? If you make a mold for hollow styrofoam
runners would it not work just as well for lost wax?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org