Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 6/29/2001, 1:21 PM


 > > > Racing beat sells flanges for intake and outlets for whichever port
 > combo
 > > > you can devise, and IIRC they are 1/2" thick and cut on a water mill.
 > > >
 > > > www.racingbeat.com
 > > >
 > > > this is a newish thing for them...
 > > >
 > > > Mike Harrington

Ed Anderson wrote:
 >
 >  Mike, where on Racing Beat's web page did you see these intake flanges?
I
 > found exhaust flanges, but no intake.
 >
 > Thanks
 >
 > Ed Anderson

Not in the new catalog either.

Paul Lamar

mike h wrote:

My mistake - it was mazdatrix. Since a lot of their performance stuff is RB,
I assumed...

http://www.mazdatrix.com/fabricators.htm

although I think they have flanges already cut for the various port combos
too.

Mike

Yes. John at Mazdatrix showed me some flanges when Perry and I were
down there getting Perry's engine overhauled.

Mazdatrix is rapidly becoming our supplier of choice as John Lemon owner
is very interested in carrying the teflon encapsulated silicon oil control
O rings. 

They gave us no hassle about overhauling Perry's engine
for his airplane and did a good job. They also run the overhauled engines on 
a test stand for several hours to check it for proper operation. Perry at 
first thought they messed up on the engine balance but that did not prove 
to be true. It must have been Perry's prop.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org