Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 6/29/2001, 8:56 AM


 Thanks Bill any sales will off set my cost.

 The clearance problem is so bad that I had to hacksaw off the two
machining
 lugs on the tops of the rotor housings. Gave me another 1/4 inch.
 I had to group both tubes from one rotor directly
 over the corresponding rotor housing or I cannot get the tubes low enough.
 If I try to pass them over the center or the endhousing they are too high
 and interfere with the stock cowl.

 It is easy to use 180 bends and pass
 them over the center and endhousing. The matching problem with the
 vertical oval ports becomes severe when you tilt the tubes towards the top
 of the rotor housing. My friend John Lynch tried to model the runners in
 Pro Engineer and Solid Works. No luck! A good pattern maker can eyeball
 and carve the core patterns like an Italian sculptor. That is
 why the casting on Ferrari's and other Italian cars are so mechanical
 beautiful. Its in the genes :-)

 This is why I finally gave up and bit the economic
 bullet and decided to cast an intake manifold. I guess I am a
 perfectionist when it comes to fluid flow aerodynamics.

 For a normally aspirated engine you could use a wrap up type intake
 manifold and keep it on the same side of the engines as the end housing
 intake ports are on. There would be plenty of room over there. The turbo
 on the other hand takes a lot of that room.

 Yes, I gave a lot of thought to composites and they would work while the
 engine was running and cool air was flowing through the tubes but once
 the engine stopped I was worried about heat soak from the hot turbo.
 Also the turbo heats the intake air necessarily in the process of
 compressing it which does not help.

 Paul Lamar


Paul,
Will the design you have still allow clearance for the two injectors that are
in the housing, and the two oil injection points on the rotor housing? I am
planning on using Richard Sohn's oil metering pump adapter to inject 2 cycle
oil from a reservoir.

Bill Schertz
KIS Cruiser #4045

I don't think there is room in there Bill for those two injectors
side by side. My intention is to simplify the high pressure fuel
plumbing and use only one fuel rail on the other side of the engine
for all four injectors.

Simpler is almost always more reliable. Jim Mederer Racing Beat has also
found better BSFC because the fuel has more time to mix thoroughly
with the air. Not to mention getting the fuel system away from
the hot turbo. This picture shows pretty much what I intend to do
only with the injectors on the tops of the runners for easier service. 
Mazda put them in the center housing like that for instant throttle 
response.

No on the oil injectors as well. I intend mixing 2 cycle oil with
the fuel. Probably 2 ounces per gallon rather than one as Jim says
he needs four ounces per gallon for the the 900 HP three rotor.
I figure that is 300 HP per rotor and I may have as much as 150 HP
per rotor. I run one ounce per gallon in the fuel and use the
regular injection pump on Robin's 12A in her 1983 GSL and I can
detect no drawbacks other than the cost of the 2 cycle oil.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org