Subject: New intake manifold
From: ACRE NL
Date: 6/30/2001, 9:13 AM


Brian Trubee discovered the holy grail of tube bending.
http://www.rbwagner.com/

1 inch inside radius   1 1/4" PIPE (1.66" OD)

....................  steel    alum     stainless
90o w/(2) 2" Tangents   266-2    290-2    315-2


Brian Trubee Wrote:

I didn't discover this company, I saw someone else's post about this supplier on this newsletter.

The tubing I got was just the ticket, and the prices are great.

Brian Trubee
Redmond, Wa

This is all I found when I searched all old messages.
Looks like Ed already ordered from them. Maybe it was
Ed in an earlier post. If so thanks Ed.

BTW Ed's exhaust pipes are cannon proof.
They don't even discolor from the heat :-) Heavy though
at .140 thick wall 1-1/2 inch pipe.

Well then I messed up by not looking into it when it was first posted.

The bends above looks ideal for a tight intake manifold to fit the
stock turbo. I will need eight of them to make the first
big U turn.

Every where I checked prior to this I could
not find anything tighter than a 2.5 inch center line
radius. The center line radius on this is about 1 -13/16
which is near perfect for a 4 port turbo manifold.

Pipe sizes are fine for intake manifolds and pipe
is cheaper than tube due to the tolerances under which
it is manufactured. It is also smoother inside than
sand castings.

Paul Lamar



Subject:        Source of bends
   Date:        Fri, 09 Feb 2001 19:46:28 -0800
   From:        Paul <rotaryeng@earthlink.net>

Not sure that this company will work out as a source of bends- they sell
architectural rails and such. I'm in the process of finding out more.
Go
here-   www.RBWagner.com
I'll keep you posted
Brian Trubee

Ed Anderson wrote:

Brian,
    RB Wagner was the source of the schedule 40 stainless steel pipe I use
for my 13B exhaust system.  They have a catalog of almost every possible
radius bend, tube dia, wall thickness you could want.  They can also make
custom bends in pipe that would spell you name (expensive though).  The
ready made bends of not only the common 45 90 180 deg but anything from
0 -360.  Clearly ordering from their stock bends and sizes is the cheaper
route to go.

   For small orders it can take a little time as they do it during their
slack periods.

Ed Anderson 

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

pipe_sizes.gif