Subject: Plugged Rads FS new condition Griffen Rad
From: ACRE NL
Date: 7/1/2001, 10:10 PM


    Perry,  could you describe the cabin heat cooler installation in a
few words or post a pic?
Jerry


"Perry J. Mick" wrote:

You can see the little ducting around it in the picture of my
plane on my website.  Paul also has the picture.  It's mounted
outside the airplane under the pilot's seat, there just wasn't
room to put it inside the plane.  Coolant always flows through
it, so most of the heat goes to the airstream and helps cool
the engine.  However I have a little hole cut in the floor with
a little door on it, I can control the amount of heated air that
enters the cockpit. Works great.


    BTW,  I have a new condition Griffen Rad that I had built several
years ago that might be of interest to you.  It is 292 cu. in.
Outside measurements are 12 x 13 x 2.5.   Sell, trade,
loan--condition guaranteed.---Jerry


Don't have an immediate need.  I've had a custom-built CCRacing rad
for several months now, just delayed installing it.  It is 13 x 18 x 2, I
think.  The size you have is about right for a Long-EZ or similar single-
wide airplane and fits well under the engine.  Maybe someone on the
list can use it.
--
Perry Mick
Duckt N7XR
http://www.ductedfan.com

"about right for a Long-EZ"
With good cowl sealing and good exit ducts :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Perry-Mick-rad-duct-right_new3.gif

Perry-Mick-great-pict2.jpg