Subject: Plugged Rads FS new condition Griffen Rad
From: ACRE NL
Date: 7/1/2001, 5:32 PM


 > Perry Mick wrote:
 >
 > OK it all makes sense now.  I removed the rads this morning, both
 > main rads were plugged!  My plane was cooling only by the 1x3x9
 > cabin heat cooler plumbed from the heater port.  It's amazing it
 > worked as well as it did.
 >
 > BTW, I think this is a good safety feature, especially if you have
 > a thermostat.  The heater port is a good thermostat bypass for
 > backup.  Even with a thermostat my plane tended to run very
 > cool because the heater port was always in use.
 >
 > I think what happened is since my rads are the bottom of the
 > system, the Barsleak junk settled to the bottom and plugged the
 > rads.
 >
 > I remember Paul remarking how well my rads were cooling.
 > Well, actually they weren't cooling at all!  The one side was
 > hot because it was near the heater rad return near the pump
 > inlet, and the other side was cold because there was nothing
 > flowing through there!
 >
 > Live and learn, it just gives me the opportunity to put in the
 > improvements I had already been planning for some time.
 >
 >

    Perry,  could you describe the cabin heat cooler installation in a
few words or post a pic?


    BTW,  I have a new condition Griffen Rad that I had built several
years ago that might be of interest to you.  It is 292 cu. in.
Outside measurements are 12 x 13 x 2.5.   Sell, trade,
loan--condition guaranteed.---Jerry

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org