Bulent Aliev wrote:

Hi Paul, I took couple of pic's for you to see the clearance between the
Ubends from Burns and the way I shaped the two runners on the middle and the
flange I made more or less by hand. I have to buy 2" tube bends to cover the
outboard intake openings.

Those third gen and 13B Cosmo intake ports sure are huge.
You guys are going to have a bunch of power.

Second picture.

Paul Lamar

Ken Powell wrote:

I give up.  Why are you guys putting yourselves thru this?  Just build a PP and
build a SIMPLE intake manifold for it.  Just Joking - but what a tough project!

Ken Powell
kenpowell@aristotle.net

It sure is. I am learning a lot about casting & patterns so a cast manifold
may materialize yet.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org