Subject: Wing leading edge air intakes.
From: ACRE NL
Date: 7/2/2001, 5:31 PM


Jerry Hey wrote:

 Paul,  This is probably a flight of fancy, but every time I see a
 Formula One car, I wonder why we can't design a plane with rad
 intakes on the inboard  ends of the wings.   --Jerry

You can. That is a very good place.
Where are your fuel tanks?

Paul Lamar

    If this were to be done to the Tailwind, it would require  major
redesign because the wing is tapered at the fuselage interface.  It
is time for one of you engineers to start with a Mazda and a blank
piece of paper--in your spare time of course.--Jerry

It is not a big problem if you make all the right choices right from the
start :-) Lots of hindsight here :-)

A. Mount the engine as high as possible. Bump the cowl
slightly if necessary.

B. Use side exhaust.

C. Seal the cowl really well. Particularly around the prop.

D. Use large cowl flap on the sides if necessary.

E. Mount the single rad under the engine. Use a custom
oil pan if necessary for more clearance.

F. Keep the rad air intake as low as possible to take
full advantage of the maximum prop slip stream velocity.

G. Seal the cowl really well. Particularly around the prop.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org