Jerry Hey wrote:
Paul (and Bill Freeman) I hate to write this because it really
reveals my ignorance (but who was I kidding anyway). According to
the Bingelis books the height of a NACA opening is related to its
width: an aspect ratio of 3-5 (width divided by height). The
example given shows a 3" wide opening and a 3/4" height. I have
worked the simple arithmetic every way I can think and cannot come
out with this result. I also graphed his example and came out with
different values than shown: a 3/4" height with a 7º ramp is not
6.75" in length but 6.17".
My question is twofold: what is the height of a 10 " (and 12") wide
NACA duct opening? And how did you derive it? ( RE: Page 187 The
SportPlane Builder) and page 198,199 of Sport Plane Construction
Techniques). I already accept that it is I who am screwed up and not
Tony who was one of my gods.
Jerry
I don't have either one of those books Jerry.
If it is 3:1 it is 4 inches deep if it is 5:1 it is 2.4 inches
deep based on a 12 inch wide duct.
That still will not give you enough
inlet area. The duct must be 18 inches wide and about 6 inches deep
for about 108 square inches inlet area. This should cut into
your baggage area somewhat but not too bad. Start the duct up
under the pilot and passenger seats if you can.
Use a side exhaust.
According to this handy chart 7 degrees is 1.5 inches
per foot so six inches deep gives you a NACA duct
4 feet long. Do you have that much room?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org