Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 7/3/2001, 8:46 AM

Neal Scherm wrote:

I just had a neat 180 degree over engine intake manifold made by a guy in
Fresno for my 13b. It uses a 4 into 2 short manifold with 2- 180 degree
tubes that put the throttle body and fuel pumps on the COLD side of the
engine. You can have the injectors on the throttle body or use the original
location on the block. I'll have him send some pics of the mockup he made.
I think he can make more since he has the programing and drawings from mine.
If any one's interested in one e-mail him at steveand1@mediaone.net .

 I want the final manifold to
be one peice tube, flange to flange. He's also making a low profile billet
waterpump/thermostat housing with AN fittings for the radiator conections
and a standard filler cap that will fit inside a KIS cruiser cowl.

Regards,
Neal

Looks great Neal. Perhaps a bit too long. Looks like it 
will work real well for a normally aspirated Kis Cruiser.
I think you will have to move that oil filler neck and shorten 
the tubes to a total of 18 - 24 inches. Also you could use a plenum 
and one larger throttle body if you wanted. You would still 
need four injectors. Don't forget a nice radius lip on the tubes
where they join the plenum. Worth 5% more HP.

BTW I hope you are planning on using a 2.85:1 PSRU as I think
you will need the extra RPM and consequent extra HP with a NA 13B 
Kis Cruiser.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Neal-Scherm-intake.JPG