Jerry Hey wrote:
Paul (and Bill Freeman) I hate to write this because it really
reveals my ignorance (but who was I kidding anyway). According to
the Bingelis books the height of a NACA opening is related to its
width: an aspect ratio of 3-5 (width divided by height). The
example given shows a 3" wide opening and a 3/4" height. I have
worked the simple arithmetic every way I can think and cannot come
out with this result. I also graphed his example and came out with
different values than shown: a 3/4" height with a 7º ramp is not
6.75" in length but 6.17".
My question is twofold: what is the height of a 10 " (and 12") wide
NACA duct opening? And how did you derive it? ( RE: Page 187 The
SportPlane Builder) and page 198,199 of Sport Plane Construction
Techniques). I already accept that it is I who am screwed up and not
Tony who was one of my gods.
Jerry
I don't have either one of those books Jerry.
If it is 3:1 it is 4 inches deep if it is 5:1 it is 2.4 inches
deep based on a 12 inch wide duct.
That still will not give you enough
inlet area. The duct must be 18 inches wide and about 6 inches deep
for about 108 square inches inlet area. This should cut into
your baggage area somewhat but not too bad. Start the duct up
under the pilot and passenger seats if you can.
Use a side exhaust.
According to this handy chart 7 degrees is 1.5 inches
per foot so six inches deep gives you a NACA duct
4 feet long. Do you have that much room?
Paul Lamar
I have room for two 12" wide ducts ten inches apart which works out
to 96 in sq intake. The inlet ramps will be 32.5" long. According
to the text I am studying in wind tunnel tests a parallel sided ramp
showed a sharp decline in pressure recovery at the inlet at Mach
numbers between 0.75 and 0.82 while this did not occur with the NACA
divergent wall inlet until Mach 0.90 was exceeded. Am I wrong in
interpreting this to mean that these two designs perform about the
same as long as I stay below Mach .75 (around 500 mph)? Jerry
That is what it sounds like. What technical paper or book are
you referring too?
Two ramps may not recover as much air as one ramp with the
same inlet area due to higher skin friction.
I assume they are ten inches apart because you are still running
a bottom exhaust.
Are you going to run your exhaust pipe down between them? :-)
What happens if the ball is not centered on climb
out? I think it is a bad idea to run your exhaust
pipe out the bottom.
Water cooled aircraft engines
do not have the benefit of a large temperature difference
between air temp and water temp. Only roughly 100 degrees
F while air cooled engines enjoy about 300 degrees F.
The heat transferred is highly dependent on this temperature
difference. Small increases in air temp have a large
negative effect on the performance of the water radiator.
BTW this is why putting the rad behind an engine without
inlet ducting is also a bad idea.
Next question. How is the exhaust pipe going
to affect the aerodynamic performance of the twin NACA ducts?
The design and performance assumes more or less undisturbed air.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org