Subject: NACA Ducts (one last time)
From: ACRE NL
Date: 7/4/2001, 9:32 PM


 > >Jerry Hey wrote:

 I have room for two 12" wide ducts  ten inches apart which works out
 to 96 in sq intake.  The inlet ramps will be 32.5" long.  According
 to the text I am studying in wind tunnel tests a parallel sided ramp
 showed a sharp decline in pressure recovery at the inlet at Mach
 numbers between 0.75 and 0.82 while this did not occur with the NACA
 divergent wall inlet until Mach 0.90 was exceeded. Am I wrong in
 interpreting this to mean that these two designs perform about the
 same as long as I stay below Mach .75 (around 500 mph)?  Jerry

   Jerry,
     The little bit of info about parallel wall NACA
ramps being as efficient as divergent walls will save
me a lot of work. I plan to put my radiators in wing
strakes behind firewall on my "Delta" and had not seen
info about parallel walled ducts being as good up to
about .75 mach(I should be able to stay under that
speed).

--   Thanks
     Kelly Troyer
Dyke Delta/13B Rotary Power

Ken Powell wrote:

Jerry,
I think that your openings are large enough.  Fred Morino's research showed that we need ~50 sq in for the radiator and 25 sq in for the oil cooler to cool 160 HP.  Fred also stated that a larger radiator will result in lower drag.  Your BIG radiator should show a lower drag than smaller radiators, i.e., you will have less cooling drag than a 600 cu in radiator.
Ken Powell
kenpowell@aristotle.net

Ken I think Fred was assuming an ideal duct subject to full dynamic
pressure. I think the duct efficiency number mentioned  was 80% of 
full dynamic pressure. I don't see no stinking high pressure on the bottom
of these fuselages :-) If anything it is on the low side. 

The reason the NACA ducts work so well on pushers is the duct is under
the wing strakes in a high pressure area and the prop  
is sucking out the air. Even the P51 scoop took advantage
of the high pressure area under the wing.

I think Jerry needs to test this before he builds it and perhaps 
before he becomes highly disappointed. He could mount the fuselage
up side down on the back of a pickup truck.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Byron-Ward-pressure-bottom.jpg