Subject: NACA Ducts (one last time)
From: ACRE NL
Date: 7/4/2001, 4:07 PM


 > > > >  > >Jerry Hey wrote:
 >
 > > >>  I have room for two 12" wide ducts  ten inches apart which works out
 > > >>  to 96 in sq intake.  The inlet ramps will be 32.5" long.  According
 > > >>  to the text I am studying in wind tunnel tests a parallel sided ramp
 > > >>  showed a sharp decline in pressure recovery at the inlet at Mach
 > > >>  numbers between 0.75 and 0.82 while this did not occur with the NACA
 > > >>  divergent wall inlet until Mach 0.90 was exceeded. Am I wrong in
 > > >>  interpreting this to mean that these two designs perform about the
 > > >>  same as long as I stay below Mach .75 (around 500 mph)?  Jerry


    Jerry,
      The little bit of info about parallel wall NACA
 ramps being as efficient as divergent walls will save
 me a lot of work. I plan to put my radiators in wing
 strakes behind firewall on my "Delta" and had not seen
 info about parallel walled ducts being as good up to
 about .75 mach(I should be able to stay under that
 speed).

 --   Thanks
      Kelly Troyer
 Dyke Delta/13B Rotary Power

The source for  this is Tony Bingelis in Sport Plane Construction
Techniques page 199.  I would like to see it verified by another
source.  Jerry

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org