Subject: NACA Ducts (one last time)
From: ACRE NL
Date: 7/4/2001, 2:02 PM


 > >Jerry Hey wrote:

 I have room for two 12" wide ducts  ten inches apart which works out
 to 96 in sq intake.  The inlet ramps will be 32.5" long.  According
 to the text I am studying in wind tunnel tests a parallel sided ramp
 showed a sharp decline in pressure recovery at the inlet at Mach
 numbers between 0.75 and 0.82 while this did not occur with the NACA
 divergent wall inlet until Mach 0.90 was exceeded. Am I wrong in
 interpreting this to mean that these two designs perform about the
 same as long as I stay below Mach .75 (around 500 mph)?  Jerry


   Jerry,
     The little bit of info about parallel wall NACA
ramps being as efficient as divergent walls will save
me a lot of work. I plan to put my radiators in wing
strakes behind firewall on my "Delta" and had not seen
info about parallel walled ducts being as good up to
about .75 mach(I should be able to stay under that
speed).

--   Thanks
     Kelly Troyer
Dyke Delta/13B Rotary Power
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org