Subject: NACA Ducts (one last time)
From: ACRE NL
Date: 7/4/2001, 12:46 PM


 > >Jerry Hey wrote:

 I have room for two 12" wide ducts  ten inches apart which works out
 to 96 in sq intake.  The inlet ramps will be 32.5" long.  According
 to the text I am studying in wind tunnel tests a parallel sided ramp
 showed a sharp decline in pressure recovery at the inlet at Mach
 numbers between 0.75 and 0.82 while this did not occur with the NACA
 divergent wall inlet until Mach 0.90 was exceeded. Am I wrong in
 interpreting this to mean that these two designs perform about the
 same as long as I stay below Mach .75 (around 500 mph)?  Jerry


That is what it sounds like. What technical paper or book are
you referring too?

Two ramps may not recover as much air as one ramp with the
same inlet area due to higher skin friction.

I assume they are ten inches apart because you are still running
a bottom exhaust.

Are you going to run your exhaust pipe down between them? :-)
What happens if the ball is not centered on climb
out? I think it is a bad idea  to run your exhaust
pipe out the bottom.

Water cooled aircraft engines
do not have the benefit of a large temperature difference
between air temp and water temp. Only roughly 100 degrees
F while air cooled engines enjoy about 300 degrees F.
The heat transferred is highly dependent on this temperature
difference. Small increases in air temp have a large
negative  effect on the performance of the water radiator.

BTW this is why putting the rad behind an engine without
inlet ducting is also a bad idea.

Next question. How is the exhaust pipe going
to affect the aerodynamic performance of the twin NACA ducts?
The design and performance assumes more or less undisturbed air.

Paul Lamar

Hi Paul

Two side by side  because there is  competition for the center line
space with the stick and elevator torque tubes.  Also, because two
comparatively shorter ramps are much easier to install.

I am going to use a side exhaust with a simple tangential muffler.
I settled on this a couple of weeks ago simply to avoid all the
things you mentioned above.  I had nightmares about sucking carbon
monoxide back into the airplane.

I sent a drawing to Griffin today for estimate on  a 20 x 20 x 2
(800 cubes)  with a pull through fan.  The fan they offer adds almost
3 lbs so I will be looking for alternatives.

Jerry

OK Jerry. Yes of course. I forgot about the elevator push pull tube.

If the price is too high get a stock Griffin Ford 22 by 19 from
Summit Racing for $181 at a discount. It will probably be the
same Griffin core with a few minor outlet changes. You should
be able to do those your self. I intend modifying mine.
Griffin might charge you $100 just to change the position of
the outlets and inlets.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org