Subject: New cast aluminum 4 port intake manifold.
From: ACRE NL
Date: 7/4/2001, 6:50 AM


Looks great Neal. Perhaps a bit too long. Looks like it
will work real well for a normally aspirated Kis Cruiser.
I think you will have to move that oil filler neck and shorten
the tubes to a total of 18 - 24 inches. Also you could use a plenum
and one larger throttle body if you wanted. You would still
need four injectors. Don't forget a nice radius lip on the tubes
where they join the plenum. Worth 5% more HP.

BTW I hope you are planning on using a 2.85:1 PSRU as I think
you will need the extra RPM and consequent extra HP with a NA 13B
Kis Cruiser.

Paul Lamar


Paul,
On the Plenum, would it be feasable to run tubes through the plenum,
top to bottom. to accommodate the filler neck and dip stick.
Just seems the simplest thing to me !.
George (down under)


Yes. That would work. I think one would have to pipe tap the cast iron
center housing where the oil filler pipe is pressed in now and screw
in a new oil filler pipe through the hole in the plenum.

Paul Lamar


Dear Paul and Group,

How are you cutting down the oil fill tube? Could you please provide a
description. I must have been asleep when this was mentioned.

Ken Gillanders
BD4 13B

Seems the oil filler tube is right in the way of an optimum
length tuned intake manifold. The plenum wants to go right
where the tube is. You could hack saw it off and use a die grinder
to grind out a part of the tube so you could use a sharp
chisel to get the rest out. Tracy said he griped it with
vice grips and worked it back and fourth until it came
out. Make sure you do all this with the center housing
disassembled so you don't get any metal particles
in the oil system.

Paul Lamar


I placed a piece of tubing inside the oil filler tube and used it as a lever
to rock the oil filler back & forth while using a BIG screw driver as a lever and
the rotor housing as the fulcrum under the welded tab (on the side of the oil
filler tube) to pry upward.  It actually came out pretty easily.

Ken Powell
kenpowell@aristotle.net

Thanks Ken. BTW how come your signature is at the start of the message?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org