> > > Yes. That would work. I think one would have to pipe tap the cast
iron
center housing where the oil filler pipe is pressed in now and screw
in a new oil filler pipe through the hole in the plenum.
Paul Lamar
Dear Paul and Group,
How are you cutting down the oil fill tube? Could you please provide a
description. I must have been asleep when this was mentioned.
Ken Gillanders
BD4 13B
Seems the oil filler tube is right in the way of an optimum
length tuned intake manifold. The plenum wants to go right
where the tube is. You could hack saw it off and use a die grinder
to grind out a part of the tube so you could use a sharp
chisel to get the rest out. Tracy said he griped it with
vice grips and worked it back and fourth until it came
out. Make sure you do all this with the center housing
disassembled so you don't get any metal particles
in the oil system.
Paul Lamar
Paul,
I have removed the oil filler tube from two engines. You do not need to
cut it off and in fact removing it intact may save some grinding work. The
oil filler tube is pressed into the hole in the center housing. I have
found that taking a large wench and hammer I can tap and twist on the oil
fitting tube and once broken loose it can be removed intact. FWIW
Ed Anderson
Thanks Ed. Perhaps a bit of heat on the casting would also help.
Paul Lamar EGOOSP
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org